Front Brake Hose
- Secure the brake hose to strut mount.
Tightening torque:
Brake hose: 33 N.m (3.36 kgf-m, 24.3 ft-lb)
- Connect the brake hose to the front caliper body using a new gasket.
Tightening torque:
Union bolt: 18 N.m (1.84 kgf-m, 13.3 ft-lb)
- Position the disc in straight position and route the brake hose through the hole in the bracket on the wheel apron side.CAUTION: Do not twist the brake hose.
- Temporarily tighten the flare nut which connects brake pipe and hose.
- Secure the brake hose to wheel apron bracket with clamp.
- Tighten the flare nut to the specified torque.
Tightening torque:
Brake pipe flare nut: 15 N.m (1.53 kgf-m, 11.1 ft-lb)
- Bleed air from the brake system. Refer to PROCEDURE .