LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System >> Air Bleeding >> Procedure >> Master Cylinder

Master Cylinder

NOTE:
  • When the master cylinder is replaced or the reservoir tank is empty, bleed the master cylinder.
  • If bleeding of the master cylinder is not necessary, omit the following procedures, and perform bleeding of the brake line. Refer to BRAKE LINE .
  1. Fill the reservoir tank of the master cylinder with brake fluid.
    NOTE: While bleeding air, keep the reservoir tank filled with brake fluid to prevent entry of air.
  2. Disconnect the brake line at primary and secondary sides.
  3. Wrap the master cylinder with a plastic bag.
  4. Depress the brake pedal slowly and hold it.
    Fig 1: Depressing Brake Pedal
    G05032805Courtesy of SUBARU OF AMERICA, INC.
  5. Plug the outlet plug with your finger, and then release the brake pedal.
    Fig 2: Releasing Brake Pedal
    G05032806Courtesy of SUBARU OF AMERICA, INC.
  6. Repeat the step  4) and  5) several times.
  7. Remove the plastic bag.
  8. Install the brake pipe to the master cylinder.

    Tightening torque: 

    Brake pipe flare nut: 19 N.m (1.94 kgf-m, 14.0 ft-lb) 

  9. Bleed air from the brake line. Refer to BRAKE LINE .
scientia non olet · About LEMON Manuals