LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Rear Gate Latch and Actuator Assembly >> Inspection >> Lock Actuator

Lock Actuator

  1. Disconnect the rear gate latch & actuator assembly connector.
  2. Check the door lock operation when battery voltage is applied between the terminals of rear gate latch & actuator.

    Preparation tool: 

    Circuit tester 

    Fig 1: Identifying Rear Gate Latch And Actuator Assembly Connector Terminals
    G06653912Courtesy of SUBARU OF AMERICA, INC.
    Inspection conditions Terminal No.
    1 2
    OPEN + -
  3. If the actuator does not operate normally, replace the rear gate latch & actuator assembly.