Rear Door Latch and Door Lock Actuator Assembly: Removal

Disconnect the ground cable from battery.
Remove the rear door trim. Refer to REAR DOOR .
Remove the sealing cover.
CAUTION:
- Carefully remove the butyl tape. Excessive force will easily break the cover.
- If the sealing cover gets broken, replace it with a new part.
Fig 1: Removing Sealing Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove the rear door glass. Refer to REMOVAL .
Remove the rear door latch and door lock actuator assembly.
1. Disconnect the connector.
2. Remove the screws, and remove the rear door latch & door lock actuator assembly.
  
  Fig 2: Locating Rear Door Latch & Door Lock Actuator Assembly Screws
  Courtesy of SUBARU OF AMERICA, INC.