56 - 64 Ω (Remote Engine Start): Wiring Diagram

CAN communication system. See appropriate SYSTEM WIRING DIAGRAM article.

Fig 1: CAN Communication System - Wiring Diagram

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS. Disconnect the remote engine start CM connector. Using the tester, measure the resistance between terminals. Connector & terminal (B180) No. 1 - No. 2:	Is the resistance 400 Ω or more?	Related lines between remote engine start CM and main wiring harness is open, or main wiring harness is open at two places or more.	Go to step 2 .
2 CHECK RELATED LINES. Using the tester, measure the resistance between terminals. Connector & terminal (B40) No. 6 - (B180) No. 1: (B40) No. 14 - (B180) No. 2:	Is the resistance 10 Ω or more?	Repair or replace the open circuit portion of remote engine start CM related lines.	Check that the remote engine start function operates normally.