Rear Sub Frame: Installation
CAUTION:
- Be sure to use a new self-locking nut.
- Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
- Install each part in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Description" for the tightening torque. < Refer to COMPONENT , General Description. >
- Inspect the wheel alignment and adjust if necessary. < Refer to INSPECTION , Wheel Alignment. >
- Perform reinitialization of the auto headlight beam leveler system. (model with auto headlight beam leveler) < Refer to PROCEDURE , Auto Headlight Beam Leveler System. >