DTC P2402 Evaporative Emission System Leak Detection Pump Control Circuit High: Wiring Diagram

WARNING: This page is about a different variant/trim than selected.

Engine electrical system, non-turbo model < Refer to appropriate SYSTEM WIRING DIAGRAM. >

Fig 1: Evaporative Emission System Leak Detection Pump Control Circuit High - Wiring Diagram

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND LEAK CHECK VALVE ASSEMBLY CONNECTOR. Turn the ignition switch to OFF. Disconnect the connector from the leak check valve assembly. Turn the ignition switch to ON. Measure the voltage between leak check valve assembly and chassis ground. Connector & terminal (R400) No. 4 (+) - Chassis ground (-):	Is the voltage 10 V or more?	Repair the short circuit to power in harness between ECM and leak check valve assembly connector.	Go to step 2 .
2 CHECK LEAK CHECK VALVE ASSEMBLY. Turn the ignition switch to OFF. Check the vacuum pump of the leak check valve assembly. < Refer to CHECK VACUUM PUMP , INSPECTION, Leak Check Valve Assembly. >	Is the vacuum pump of the leak check valve assembly OK?	Repair the poor contact in the leak check valve assembly connector.	Replace the leak check valve assembly. < Refer to LEAK CHECK VALVE ASSEMBLY . >