DTC P2092 Intake Camshaft Position Actuator Control Circuit Low (Bank 2): Wiring Diagram

WARNING: This page is about a different variant/trim than selected.

Engine electrical system, non-turbo model < Refer to appropriate SYSTEM WIRING DIAGRAM. >

Fig 1: Intake Camshaft Position Actuator Control Circuit Low - Wiring Diagram (Bank 2)

Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND OIL CONTROL SOLENOID LH CONNECTOR. Turn the ignition switch to OFF. Disconnect the connectors from ECM and oil control solenoid LH. Measure the resistance of harness between ECM and oil control solenoid LH connector. Connector & terminal (B134) No. 17 - (E37) No. 1: (B134) No. 16 - (E37) No. 2:	Is the resistance less than 1 Ω?	Go to step 2 .	Repair the harness and connector. NOTE: In this case, repair the following item: Open circuit in harness between ECM and oil control solenoid LH connector Poor contact of coupling connector
2 CHECK HARNESS BETWEEN ECM AND OIL CONTROL SOLENOID LH CONNECTOR. Measure the resistance between ECM and chassis ground. Connector & terminal (B134) No. 17 - Chassis ground: (B134) No. 16 - Chassis ground:	Is the resistance 1 MΩ or more?	Go to step 3 .	Repair the short circuit to ground in harness between ECM and oil control solenoid LH connector.
3 CHECK OIL CONTROL SOLENOID. Measure the resistance between oil control solenoid terminals. Terminals No. 1 - No. 2:	Is the resistance 6 - 12 Ω?	Repair the poor contact of ECM and oil control solenoid LH connector.	Replace the oil control solenoid LH. < Refer to OIL CONTROL SOLENOID . >