DTC P2089 Intake Camshaft Position Actuator Control Circuit High (Bank 1): Wiring Diagram

WARNING: This page is about a different variant/trim than selected.

Engine electrical system, non-turbo model < Refer to appropriate SYSTEM WIRING DIAGRAM. >

Fig 1: Intake Camshaft Position Actuator Control Circuit High - Wiring Diagram (Bank 1)

Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND OIL CONTROL SOLENOID RH CONNECTOR. Turn the ignition switch to OFF. Disconnect the connectors from ECM and oil control solenoid RH. Measure the voltage between ECM and chassis ground. Connector & terminal (B134) No. 34 (+) - Chassis ground (-): (B134) No. 27 (+) - Chassis ground (-):	Is the voltage less than 1 V?	Go to step 2 .	Repair the short circuit to power supply in harness between ECM and oil control solenoid RH connector.
2 CHECK HARNESS BETWEEN ECM AND OIL CONTROL SOLENOID RH CONNECTOR. Measure the resistance of harness between ECM and oil control solenoid RH connector. Connector & terminal (B134) No. 34 - (E38) No. 1: (B134) No. 27 - (E38) No. 2:	Is the resistance less than 1 Ω?	Go to step 3 .	Repair the harness and connector. NOTE: In this case, repair the following item: Open circuit in harness between ECM and oil control solenoid RH connector Poor contact of coupling connector
3 CHECK OIL CONTROL SOLENOID. Measure the resistance between oil control solenoid terminals. Terminals No. 1 - No. 2:	Is the resistance 6 - 12 Ω?	Repair the poor contact of ECM and oil control solenoid RH connector.	Replace the oil control solenoid RH. < Refer to OIL CONTROL SOLENOID . >