LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester XT Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (M/T Clutch System) >> Release Bearing and Lever >> Removal

Release Bearing and Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. < Refer to REMOVAL , Manual Transmission Assembly. >
  2. Remove the two clips from the release lever and remove the release bearing.
    CAUTION: Be careful not to deform the clips.
  3. Remove the dust cover.
    Fig 1: Identifying Release Lever And Dust Cover
    G08571795Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the lever spring from the pivot with a screwdriver by accessing it through the clutch housing release lever hole. Then remove the release lever.
    Fig 2: Removing Lever Spring From Pivot With Screwdriver
    G08571796Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals