Water Pump Pulley

WARNING: This page is about a different variant/trim than selected.

Using the ST, install the water pump pulley.
ST1 18355AA000 PULLEY WRENCH

ST2 18334AA030 PULLEY WRENCH PIN SET

Tightening torque:

14 N.m (1.4 kgf-m, 10.3 ft-lb)

Fig 1: Installing Water Pump Pulley Using ST
Courtesy of SUBARU OF AMERICA, INC.
Install the under cover. < Refer to INSTALLATION , Front Under Cover. >
Lower the vehicle.
Install the main fan motor assembly. < Refer to INSTALLATION , Radiator Main Fan and Fan Motor. >
Install the V-belts. < Refer to INSTALLATION , V-belt. >
Connect the battery ground terminal.

Fig 2: Connecting/Disconnecting Battery Ground Terminal
Courtesy of SUBARU OF AMERICA, INC.