LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester XT Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical (H4DO)) >> Chain Cover >> Disassembly

Chain Cover: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil filler cap.
  2. Remove the engine oil filter and the oil pump union. < Refer to REMOVAL , Engine Oil Filter. >
  3. Remove the oil pressure switch. < Refer to REMOVAL , Oil Pressure Switch. >
  4. Remove the engine oil temperature sensor. < Refer to REMOVAL , Engine Oil Temperature Sensor. >
  5. Remove the oil control solenoid. < Refer to REMOVAL , Oil Control Solenoid. >
    Fig 1: Locating Oil Filler Cap
    G08316938Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the camshaft position sensor. < Refer to REMOVAL , Camshaft Position Sensor. >
  7. Remove the actuator cover from chain cover.
    Fig 2: Locating Actuator Cover Bolts
    G08562961Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the sensor cover from chain cover.
    Fig 3: Locating Sensor Cover Bolts
    G08562962Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals