Ignition Key Lock: Inspection
- Remove the instrument panel lower cover.
- Remove the lower column cover.
- Unfasten the fixing clip which secures harness, and then disconnect the harness connector of the ignition switch from body harness.
- Turn the ignition key plate to each position and check the resistance between ignition connector terminals.
Courtesy of SUBARU OF AMERICA, INC.
| Switch position |
Terminal No. |
Standard |
| LOCK |
- |
- |
| ACC |
3 and 5 |
Less than 1 Ω |
| ON |
3 and 1 and 4
3 and 5 |
Less than 1 Ω |
| ST |
3 and 2
3 and 1 and 6 |
Less than 1 Ω |
- Replace the ignition switch if the inspection result is not within the standard value.