LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester X Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC)) >> PCV Valve >> Removal

PCV Valve: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not remove unless the PCV valve is broken.
  1. Remove the collector cover.
  2. Remove the intake manifold. < Refer to REMOVAL , Intake Manifold. >
  3. Remove the secondary air combination valve RH. < Refer to REMOVAL , Secondary Air Combination Valve. >
  4. Disconnect the vacuum hose (A) from the PCV valve and remove the PCV valve from the PCV connector.
    NOTE: Pinch the clamp of the PCV connector by fitting the cut out in the ST with the protrusion on the clamp as shown in the figure, and unlock the clamp.

    ST 18353AA000 CLAMP PLIERS

    Fig 1: Removing/Installing PCV Hose Clamp Using Clamp Pliers
    G06650572Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Locating PCV Hose Assembly Pipe And Clamp
    G08540122Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals