LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester X Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC)) >> Canister >> Installation

Section 9 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC)): Canister: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal while being careful of the following.

CAUTION:
  • Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
  • When connecting the quick connector, securely insert the pipe all the way before locking the retainer.
  • When it is difficult to lock the retainer, make sure that the pipe is securely inserted.
  • Make sure that the quick connector is securely connected.
Fig 1: Connecting Quick Connector
G08570965Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

Fig 2: Locating Canister Bracket Screws
G08538984Courtesy of SUBARU OF AMERICA, INC.
Fig 3: Locating Canister Mounting Screws
G08538985Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

18 N.m (1.8 kgf-m, 13.3 ft-lb) 

Fig 4: Locating Canister Cover Screws
G08570968Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

8 N.m (0.8 kgf-m, 5.9 ft-lb) 

Fig 5: Locating Canister Bolt
G05659583Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

18 N.m (1.8 kgf-m, 13.3 ft-lb) 

Fig 6: Locating Canister Cover Screws
G08570970Courtesy of SUBARU OF AMERICA, INC.
Fig 7: Locating Canister Bracket Screws
G08570971Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals