Intake Duct: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the collector cover.
Disconnect the ground cable from battery.

Fig 1: Disconnecting\Connecting Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.
Remove the intake manifold. < Refer to REMOVAL , Intake Manifold. >
Remove the sensor, engine harness and fuel pipe from the intake manifold. < Refer to DISASSEMBLY , Intake Manifold. >
Remove the intake duct from intake manifold.

Fig 2: Locating Intake Duct Nut
Courtesy of SUBARU OF AMERICA, INC.
Remove the PCV hose assembly from the intake duct.
NOTE: Pinch the clamp of the PCV hose assembly by fitting the cut out in the ST with the protrusion on the clamp as shown in the figure, and unlock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 3: Pinching Clamp Of PCV Hose Assembly Using ST
Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Locating PCV Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.