LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester X Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Intake System (Induction) And Turbocharger (H4DOTC)) >> Air Cleaner Case >> Removal

Air Cleaner Case: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting\Connecting Battery Ground Cable
    G06336085Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the air intake duct (rear). < Refer to REMOVAL , Air Intake Duct. >
  4. Disconnect the connector (A) from air flow and intake air temperature sensor.
  5. Loosen the clamp (B) which holds the air intake boot.
  6. Remove the clip (C) from the air cleaner case (front).
    Fig 2: Identifying Air Temperature Sensor Connector, Boot Clamp And Clip
    G05660674Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the air cleaner case (rear) and air intake boot.
  8. Remove the air cleaner element.
  9. Remove bolts (A) and nuts (B) which secure the air cleaner case (front) to the body, and remove the air cleaner case (front).
    Fig 3: Identifying Air Cleaner Case Bolts And Nuts
    G05955014Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals