Enable Conditions
WARNING: This page is about a different variant/trim than selected.
ENABLE CONDITION
| Secondary Parameters | Enable Conditions |
|---|---|
| Activation of soaking timer | Completed |
| Battery voltage | ≥ 10.9 V |
| Ignition switch | OFF |
| Engine coolant temperature | ≥ 4.4 °C (39.9 °F) |
| and | |
| < 45 °C (113 °F) | |
| Atmospheric pressure | ≥ 75 kPa (563 mmHg, 22.2 inHg) |
| and | |
| < 110 kPa (825 mmHg, 32.5 inHg) | |
| EVAP conc. learning during previous driving cycle | Done |
| Learning value of EVAP conc. during previous driving cycle | ≤ 0.2 |
| Accumulated purge amount during previous driving cycle | ≥ Value of Map 1 |
MAP 1
| Engine coolant temperature °C (°F) |
0 (32) | 30 (86) | 45 (113) |
| Accumulated purge amount during previous driving cycle g (oz) |
3000 (105.81) | 3000 (105.81) | 10000 (352.7) |