LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester X Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Lubrication System (H4DOTC)) >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the ST, install the front oil seal.

    ST 499587100 OIL SEAL INSTALLER

    NOTE:

    Use a new front oil seal.

    Fig 1: Installing Front Oil Seal Using Oil Seal Installer
    G04997893Courtesy of SUBARU OF AMERICA, INC.
  2. Apply liquid gasket to the mating surfaces of oil pump.
    NOTE:

    Install within 5 min. after applying liquid gasket.

    Liquid gasket: 

    THREE BOND 1217G (Part No. K0877Y0100) or equivalent 

    Fig 2: Identifying Liquid Gasket Applying Areas On Mating Surfaces Of Oil Pump
    G05333114Courtesy of SUBARU OF AMERICA, INC.
  3. Apply a coat of engine oil to the inside of front oil seal.
    Fig 3: Identifying Engine Oil Applying Areas On Inside Of Front Oil Seal
    G04997765Courtesy of SUBARU OF AMERICA, INC.
  4. Install the oil pump to cylinder block.
    CAUTION:
    • Be careful not to damage the front oil seal during installation.
    • Make sure the front oil seal lip is not folded.
    NOTE:
    • Align the flat surface of oil pump's inner rotor with that of crankshaft before installation.
    • Use new O-rings.
    • Do not forget to assemble O-rings.
  5. Apply liquid gasket to the three bolts thread shown in figure. (when reusing bolts)

    Liquid gasket: 

    THREE BOND 1324 (Part No. 004403042) or equivalent 

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 4: Applying Liquid Gasket To Three Bolts Thread
    G07909946Courtesy of SUBARU OF AMERICA, INC.
  6. Install the crank sprocket. < Refer to INSTALLATION , Crank Sprocket. >
  7. Install the water pump. < Refer to INSTALLATION , Water Pump. >
  8. Install the crankshaft position sensor. < Refer to INSTALLATION , Crankshaft Position Sensor. >
  9. Install the radiator. < Refer to INSTALLATION , Radiator. >
  10. Connect the battery ground terminal.
    Fig 5: Connecting Ground Cable From Battery
    G06336085Courtesy of SUBARU OF AMERICA, INC.
  11. Install the collector cover.
scientia non olet · About LEMON Manuals