Section 8 (Engine Cooling System (H4DOTC)): Thermostat: Installation

WARNING: This page is about a different variant/trim than selected.

Install a gasket to thermostat.
NOTE: Use a new gasket.
Install the thermostat and thermostat cover.
NOTE: Install the parts with the jiggle pin facing upside.

Tightening torque:

9 N.m (0.9 kgf-m, 6.6 ft-lb)

Fig 1: Exploded View Of Thermostat With Torque Specification
Courtesy of SUBARU OF AMERICA, INC.
Connect the radiator outlet hose to thermostat cover.
Install the under cover. Refer to FRONT UNDER COVER .
Lower the vehicle.
Fill engine coolant. Refer to , FILLING OF ENGINE COOLANT .