LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Diagnostics (H4DOTC)) >> Drive Cycle >> Procedure >> Drive Cycle E >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
  1. Make sure that the battery voltage is 10.9 V or more.
  2. Perform the Clear Memory Mode. Refer to , CLEAR MEMORY MODE .
  3. Drive the vehicle for the distance equal to the fuel of 30 2 (7.9 US gal, 6.6 Imp gal).
    NOTE:
    • It is acceptable to drive the vehicle intermittently.
    • Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)
scientia non olet · About LEMON Manuals