LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Diagnostics (H4DOTC)) >> Drive Cycle >> Procedure >> Drive Cycle D >> Diagnostic procedure >> Drift Diagnosis

Drift Diagnosis

WARNING: This page is about a different variant/trim than selected.
  1. Make sure of the items below before starting the engine.
    • Engine coolant temperature is less than 30°C (86°F).
    • Remaining fuel is 10 2 (2.6 US gal, 2.2 Imp gal) or more.
    • Battery voltage is 10.9 V or more.
  2. Idle the engine until engine coolant temperature is at least 10°C (18°F) higher than it was when engine started.
  3. After the engine has reached the state of procedure 2), idle the engine for another 5 minutes or more.
scientia non olet · About LEMON Manuals