Fuel Pump Circuit
WARNING: This page is about a different variant/trim than selected.
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Refer to
, OPERATION , Clear Memory Mode., and Inspection Mode Refer to
, PROCEDURE , Inspection Mode..
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK OPERATING SOUND OF FUEL PUMP. Make sure that the fuel pump operates for two seconds when turning the ignition switch to ON.
NOTE:
Fuel pump operation can be executed using the Subaru Select Monitor.
For detailed procedures, refer to "SYSTEM OPERATION CHECK MODE". Refer to , SYSTEM OPERATION CHECK MODE . |
Does the fuel pump emit operating sound? | Check the fuel injector circuit. Refer to , FUEL INJECTOR CIRCUIT , Diagnostics for Engine Starting Failure. | Display the DTC. Refer to , OPERATION , Read Diagnostic Trouble Code (DTC). |