DTC P2009 Intake Manifold Runner Control Circuit Low (Bank 1): Wiring Diagram

WARNING: This page is about a different variant/trim than selected.

Fig 1: Intake Manifold Runner Control Circuit Diagram (Low) (Bank 1)

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND TUMBLE GENERATOR VALVE ASSEMBLY RH CONNECTOR. Turn the ignition switch to OFF. Disconnect the connectors from ECM. Measure the voltage between ECM and chassis ground. Connector & terminal (B134) No. 25 (+) - Chassis ground (-): (B134) No. 26 (+) - Chassis ground (-):	Is the voltage 5 V or more?	Repair the short circuit to power in harness between ECM and tumble generator valve assembly RH connector.	Replace the tumble generator valve assembly RH. Refer to FU(H4DOTC)-47, Tumble Generator Valve Assembly.