DTC P0336 Crankshaft Position Sensor "A" Circuit Range/Performance: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.

Engine stalls.
Failure of engine to start
CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Refer to , OPERATION , Clear Memory Mode., and Inspection Mode Refer to , PROCEDURE , Inspection Mode..

Step	Check	Yes	No
1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR. Turn the ignition switch to OFF.	Is the crankshaft position sensor installation bolt tightened securely?	Go to step 2 .	Tighten the crankshaft position sensor installation bolt securely. Refer to CRANKSHAFT POSITION SENSOR Crankshaft Position Sensor.
2 CHECK CRANK SPROCKET. Remove the timing belt cover. Refer to TIMING BELT COVER REMOVAL, Timing Belt Cover.	Are crank sprocket teeth cracked or damaged?	Replace the crank sprocket. Refer to CRANK SPROCKET Crank Sprocket.	Go to step 3 .
3 CHECK INSTALLATION CONDITION OF TIMING BELT. Turn the crankshaft using ST, and align the alignment mark on crank sprocket with alignment mark on cylinder block. ST 499987500 CRANKSHAFT SOCKET	Is the timing belt dislocated from its proper position?	Repair the installation condition of timing belt. Refer to TIMING BELT Timing Belt.	Replace the crankshaft position sensor. Refer to CRANKSHAFT POSITION SENSOR Crankshaft Position Sensor.