DTC P0222 Throttle/Pedal Position Sensor/Switch "B" Circuit Low: Wiring Diagram

WARNING: This page is about a different variant/trim than selected.

Fig 1: Throttle/Pedal Position Sensor/Switch Circuit Diagram (Low)

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR. Turn the ignition switch to OFF. Disconnect the connectors from the ECM and electronic throttle control. Measure the resistance between ECM and chassis ground. Connector & terminal (B134) No. 19 - Chassis ground: (B134) No. 28 - Chassis ground:	Is the resistance 1 MΩ or more?	Go to step 2 .	Repair the ground short circuit of harness between ECM and electronic throttle control connector.
2 CHECK SHORT CIRCUIT INSIDE THE ECM. Connect the connector to ECM. Measure the resistance between electronic throttle control connector and engine ground. Connector & terminal (E57) No. 4 - Engine ground:	Is the resistance 1 MΩ or more?	Replace the electronic throttle control. Refer to THROTTLE BODY Throttle Body.	Repair the ground short circuit of harness between ECM and electronic throttle control connector. Replace the ECM if defective. Refer to ENGINE CONTROL MODULE (ECM) Engine Control Module (ECM).