DTC P0111 Intake Air Temperature Sensor 1 Circuit Range/Performance: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.

Improper idling
Poor driving performance
CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Refer to , OPERATION , Clear Memory Mode., and Inspection Mode Refer to , PROCEDURE , Inspection Mode..

Step	Check	Yes	No
1 CHECK ENGINE COOLANT TEMPERATURE. Start the engine and warm up completely. Measure the engine coolant temperature using the Subaru Select Monitor or general scan tool. NOTE: Subaru Select Monitor For detailed operation procedures, refer to "READ CURRENT DATA FOR ENGINE". Refer to , SUBARU SELECT MONITOR . General scan tool For detailed operation procedures, refer to the general scan tool operation manual.	Is the engine coolant temperature 75°C (167°F) or higher?	Replace the mass air flow and intake air temperature sensor. Refer to MANIFOLD ABSOLUTE PRESSURE SENSOR Mass Air Flow and Intake Air Temperature Sensor.	Go to DTC P0125. Refer to , DTC P0125 INSUFFICIENT COOLANT TEMPERATURE FOR CLOSED LOOP FUEL CONTROL , Diagnostic Procedure with Diagnostic Trouble Code (DTC).