LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (H4DOTC)) >> Engine Mounting >> Removal

Engine Mounting: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Change the front hood damper mounting position from (A) to (B), and completely open the front hood.

    Tightening torque: 

    20 N.m (2.0 kgf-m, 14.8 ft-lb) 

    Fig 1: Disconnecting Ground Cable From Battery
    G06649252Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the collector cover.
  3. Disconnect the ground cable from battery.
    Fig 2: Supporting Engine With Lifting Device And Wire Ropes
    G07911884Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the intercooler. Refer to INTERCOOLER .
  5. Remove the radiator main fan motor assembly and radiator sub fan motor assembly. Refer to RADIATOR MAIN FAN AND FAN MOTOR . Refer to RADIATOR SUB FAN AND FAN MOTOR .
  6. Lift up the vehicle.
  7. Remove the under cover. Refer to FRONT UNDER COVER .
  8. Remove the front exhaust pipe. Refer to FRONT EXHAUST PIPE .
  9. Lower the vehicle.
  10. Support the engine with a lifting device and wire ropes.
    Fig 3: Identifying Stopper Rod
    G04997613Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the stopper rod.
    Fig 4: Locating Engine Mounting Bolts
    G06650652Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the bolt and nut which secure engine mounting to the cradle.
    Fig 5: Locating Engine Mounting Bolts
    G06650685Courtesy of SUBARU OF AMERICA, INC.
  13. Lift up the vehicle.
    CAUTION: When lifting up the vehicle, raise up wire ropes at the same time.
  14. Remove the bolts which secure the engine mounting onto the engine, and remove the engine mounting.
    Fig 6: Locating Engine Mounting Bolts
    G06650654Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals