Engine Mounting: Installation

1. Set the engine mounting, and tighten the bolts which hold engine mounting to the engine.

   Tightening torque: 

   58 N.m (5.9 kgf-m, 42.8 ft-lb) 

   Fig 1: Locating Engine Mounting Bolts And Nuts

   Courtesy of SUBARU OF AMERICA, INC.
2. Lower the vehicle.
   CAUTION: When lifting down the vehicle, lower wire ropes at the same time.
3. Attach the bolts and nuts which secure engine mounting to the cradle.

   Tightening torque: 

   60 N.m (6.1 kgf-m, 44.3 ft-lb) 

   Fig 2: Installing Stopper Rod

   Courtesy of SUBARU OF AMERICA, INC.
4. Install the stopper rod.

   Tightening torque: 

   36 N.m (3.7 kgf-m, 26.6 ft-lb) 

   Fig 3: Removing Lifting Device And Wire Ropes

   Courtesy of SUBARU OF AMERICA, INC.
5. Remove the lifting device and wire ropes.
   Fig 4: Connecting Ground Cable To Battery

   Courtesy of SUBARU OF AMERICA, INC.
6. Lift up the vehicle.
7. Install the front exhaust pipe. Refer to FRONT EXHAUST PIPE .
8. Install the under cover. Refer to FRONT UNDER COVER .
9. Lower the vehicle.
10. Install the radiator main fan motor assembly and radiator sub fan motor assembly. Refer to RADIATOR MAIN FAN AND FAN MOTOR . Refer to RADIATOR SUB FAN AND FAN MOTOR .
11. Install the intercooler. Refer to INTERCOOLER .
12. Connect the ground cable to battery.
    Fig 5: Changing Front Hood Damper Mounting Position From (B) To (A)

    Courtesy of SUBARU OF AMERICA, INC.
13. Install the collector cover.
14. Change the front hood damper mounting position from (B) to (A), and close the front hood.

Tightening torque: 

20 N.m (2.0 kgf-m, 14.8 ft-lb) 

Fig 6: Locating Turbocharger Upper Stay Clamping Bolts

Courtesy of SUBARU OF AMERICA, INC.