LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (H4DOTC)) >> Cylinder Block >> Disassembly

Cylinder Block: Disassembly

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Connecting Rod And Crankshaft Components
G07912098Courtesy of SUBARU OF AMERICA, INC.
  1. Remove the connecting rod cap.
  2. Remove the connecting rod bearing.
    NOTE: Keep the removed connecting rods, connecting rod caps and bearings in order so that they are kept in their original combinations/groups, and not mixed together.
  3. Remove the piston rings using piston ring expander.
  4. Remove the oil ring by hand.
    NOTE: Arrange the removed piston rings in proper order, to prevent confusion.
  5. Remove the snap ring.
scientia non olet · About LEMON Manuals