Cam Sprocket: Installation

WARNING: This page is about a different variant/trim than selected.

Install the cam sprocket.
Use the ST to lock the cam sprocket, and install the cam sprocket bolt.
NOTE: Do not confuse cam sprockets (LH) and (RH) or (INT) and (EXH) during installation.

ST 499977500 CAM SPROCKET WRENCH

Tightening torque:

Tighten to 30 N.m (3.1 kgf-m, 22.1 ft-lb) of torque, and then tighten further by 45°.

Fig 1: Locating Crank Sprocket
Courtesy of SUBARU OF AMERICA, INC.
Install the actuator covers of intake cam sprocket and exhaust cam sprocket.
NOTE: Use new O-rings.

Tightening torque:

3.4 N.m (0.3 kgf-m, 2.5 ft-lb)
Install the timing belt. Refer to , INSTALLATION , Timing Belt.
Install the timing belt cover. Refer to , INSTALLATION , Timing Belt Cover.
Install the crank pulley. Refer to , INSTALLATION , Crank Pulley.