Section 5 (Engine Intake Induction (H4DOTC)): Turbocharger: Assembly

1. Install the exhaust stay to the turbocharger.

   Tightening torque: 

   6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

   Fig 1: Locating Turbocharger Exhaust Stay Mounting Bolt

   Courtesy of SUBARU OF AMERICA, INC.
2. Install the exhaust cover to the turbocharger.

   Tightening torque: 

   6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

   Fig 2: Locating Turbocharger Exhaust Cover Mounting Bolt

   Courtesy of SUBARU OF AMERICA, INC.
3. Install the water pipe connector to the turbocharger.
   NOTE: Use a new gasket.

   Tightening torque: 

   36.5 N.m (3.7 kgf-m, 26.9 ft-lb) 

   Fig 3: Locating Turbocharger Water Pipe Connector

   Courtesy of SUBARU OF AMERICA, INC.
4. Install the water pipe to the turbocharger.
   NOTE: Use a new gasket.

   Tightening torque: 

   31.5 N.m (3.2 kgf-m, 23.2 ft-lb) 

   Fig 4: Locating Turbocharger Water Pipe Clamping Bolts

   Courtesy of SUBARU OF AMERICA, INC.
5. Install the oil inlet pipe to the turbocharger.

Tightening torque: 

T1: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

T2: 16 N.m (1.6 kgf-m, 11.8 ft-lb) 

Fig 5: Identifying Turbocharger Oil Inlet Pipe Clamping Bolts

Courtesy of SUBARU OF AMERICA, INC.