Oil Catch Tank: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.

NOTE:

Use a new gasket.
When installing the oil catch tank, tighten to the specified torque in the alphabetical order shown in the figure.

Tightening torque:

T1: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

T2: 10.5 N.m (1.1 kgf-m, 7.7 ft-lb)

Fig 1: Turbocharger Oil Catch Tank Mounting Bolts With Torque Specification

Courtesy of SUBARU OF AMERICA, INC.

Use a new clamp for the vacuum hose, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 2: Identifying Clamp Pliers (ST 18353AA000)

Courtesy of SUBARU OF AMERICA, INC.

After installing, check the engine oil level and replenish it if necessary. Refer to ENGINE OIL .

Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 3: Locating Engine Cover Mounting Bolts

Courtesy of SUBARU OF AMERICA, INC.