PCV Hose Assembly: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Do not remove except when the hose is broken.

Remove the collector cover.
Remove the intercooler. Refer to INTERCOOLER .
Disconnect the vacuum hose from intake manifold and remove the PCV hose assembly from cylinder block RH and blow-by pipe assembly.

NOTE: Pinch the clamp of the PCV hose assembly by fitting the cut out in the ST with the protrusion on the clamp as shown in the figure, and unlock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 1: Identifying Clamp Of PCV Hose Assembly With ST (View 1 Of 4)

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying PCV Hose (View 1 Of 2)

Courtesy of SUBARU OF AMERICA, INC.