Section 3 (Aux. Emission Control Devices (H4DOTC)): Canister: Installation

1. Connect the vent tube (A), canister drain tube (B), charge tube (C) and PCV drain tube (D) to canister, and install the canister drain tube (B) and PCV drain tube (D) to clips (E).
   CAUTION:

   • Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
   • Make sure that the quick connector is securely connected.
   NOTE: Connect the quick connector as shown in the figure.
   Fig 1: Locating Quick Connectors

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 2: Identifying Vent Tube, Canister Drain Tube, Charge Tube And PCV Drain Tube

   Courtesy of SUBARU OF AMERICA, INC.
2. Connect the connector to the drain valve.
   Fig 3: Locating Drain Valve Connector

   Courtesy of SUBARU OF AMERICA, INC.
3. Install the canister to the vehicle.

   Tightening torque: 

   8 N.m (0.8 kgf-m, 5.9 ft-lb) 

   Fig 4: Locating Canister Mounting Bolts

   Courtesy of SUBARU OF AMERICA, INC.
4. Secure the rear wiring harness with clip.
   Fig 5: Locating Rear Wiring Harness Mounting Clip

   Courtesy of SUBARU OF AMERICA, INC.
5. Attach all tubes to clips (E), and connect the quick connectors of the vent tube (A), canister drain tube (B), charge tube (C) and PCV drain tube (D).
   CAUTION:

   • Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
   • Make sure that the quick connector is securely connected.
   NOTE: Connect the quick connector as shown in the figure.
   Fig 6: Locating Quick Connector

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 7: Identifying Vent Tube, Canister Drain Tube, Charge Tube And PCV Drain Tube

   Courtesy of SUBARU OF AMERICA, INC.
6. Install the rear mud guard LH. Refer to MUD GUARD .
7. Lower the vehicle.
8. Install the rear wheel LH.

Tightening torque: 

120 N.m (12.2 kgf-m, 88.5 ft-lb)