LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Manual Transmission And Differential) >> Transmission Mounting System >> Removal >> CROSSMEMBER And Cushion Rubber

CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the front under cover. Refer to FRONT UNDER COVER .
  4. Remove the front and center exhaust pipes. (non-turbo model) Refer to FRONT EXHAUST PIPE . Refer to CENTER EXHAUST PIPE .
  5. Remove the center exhaust pipe. (turbo model) Refer to CENTER EXHAUST PIPE .
  6. Remove the heat shield cover.
    Fig 1: Identifying Heat Shield Cover
    G05661238Courtesy of SUBARU OF AMERICA, INC.
  7. Set the transmission jack.
    CAUTION: Always support the transmission case with a transmission jack.
  8. Remove the front crossmember and the rear crossmember.
    Fig 2: Locating Front Crossmember And Rear Crossmember Mounting Bolts
    G06652274Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the transmission cushion rubber.
scientia non olet · About LEMON Manuals