Transfer Drive Gear: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the transfer drive gear.
Tightening torque:
26 N.m (2.7 kgf-m, 19.2 ft-lb)
- Install the transfer driven gear. Refer to Transfer Driven Gear .
- Install the extension case assembly.
- Install the transfer case and the extension case assembly. Refer to Transfer Case and Extension Case Assembly .
- Install the back-up light switch neutral position switch. Refer to Switches and Harness .
- Install the manual transmission assembly to the vehicle. Refer to Manual Transmission Assembly .