Thrust Bearing Preload

WARNING: This page is about a different variant/trim than selected.

Select a suitable adjusting washer No. 1 so that dimension (H) will be zero in a visual check. Position the washer (20 x 31 x 4) and lock washer (20 x 31 x 2.3) and attach the lock nut (20 x 11).

Fig 1: Identifying Adjusting Washer Dimension
Courtesy of SUBARU OF AMERICA, INC.
Using the ST1, ST2 and ST3, tighten the lock nut to the specified torque.
NOTE: Use new lock nuts and lock washers.

Tightening torque:

126 N.m (12.8 kgf-m, 92.9 ft-lb)

ST1 18680AA020 HOLDER

ST2 18667AA020 HOLDER

ST3 18662AA010 SOCKET (27)

Fig 2: Tightening Lock Nut To Specified Torque
Courtesy of SUBARU OF AMERICA, INC.
After removing the ST2 used in step 2, measure the starting torque using torque driver.
Starting torque:

0.3 - 0.8 N.m (0.03 - 0.08 kgf-m, 0.2 - 0.6 ft-lb)

ST1 18680AA020 HOLDER

ST3 18662AA010 SOCKET (27)

Fig 3: Measuring Starting Torque Using Torque Driver
Courtesy of SUBARU OF AMERICA, INC.

If the starting torque is not within the specified limit, select new adjusting washer No. 1 and recheck starting torque.

Fig 4: Identifying Adjusting Washer No. 1 And NO. 2

Courtesy of SUBARU OF AMERICA, INC.

Adjusting washer No. 1
Part number	Thickness mm (in)
803025071	2.925 (0.1152)
803025072	2.950 (0.1161)
803025073	2.975 (0.1171)
803025074	3.000 (0.1181)
803025075	3.025 (0.1191)
803025076	3.050 (0.1201)
803025077	3.075 (0.1211)

If the specified starting torque cannot be obtained by the selection of washer No. 1, select adjusting washer No. 2 from the list below. Repeat steps 1 through 4) to adjust starting torque.

Fig 5: Identifying Adjusting Washer No. 1 And NO. 2

Courtesy of SUBARU OF AMERICA, INC.

Starting torque	Dimension H	Adjusting washer No. 2
Low	Small	Select thicker one.
High	Large	Select thinner one.

Adjusting washer No. 2
Part number	Thickness mm (in)
803025070	2.850 (0.1122)
803025074	3.000 (0.1181)
803025078	3.150 (0.1240)

Recheck that the starting torque is within the specified range, then crimp the lock nut at four positions.