Transmission Rear CROSSMEMBER & Rear Cushion Rubber
WARNING: This page is about a different variant/trim than selected.
- Install the rear cushion rubber.
Tightening torque:
40 N.m (4.1 kgf-m, 29.5 ft-lb)
- Install the crossmember.
Tightening torque:
T1: 35 N.m (3.6 kgf-m, 25.8 ft-lb)
T2: 75 N.m (7.6 kgf-m, 55.3 ft-lb)
- Remove the transmission jack.
- Install the heat shield cover. Refer to HEAT SHIELD COVER .
- Install the front exhaust pipe. Refer to FRONT EXHAUST PIPE .
- Install the under cover. Refer to FRONT UNDER COVER .
- Lower the vehicle.
- Connect the battery ground terminal.