LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Automatic Transmission) >> Rear Drive Shaft >> Removal

Rear Drive Shaft: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. Refer to , REMOVAL , Automatic Transmission Assembly.
  2. Remove the rear vehicle speed sensor, and then remove the extension case. Refer to , REMOVAL , Extension Case.
  3. Pull out the rear driveshaft from center differential assembly.
    Fig 1: Identifying Rear Drive Shaft And Reduction Drive Gear
    G05022299Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the drive plate and driven plate.
scientia non olet · About LEMON Manuals