Camshaft Position Sensor (Method With Oscilloscope)

WARNING: This page is about a different variant/trim than selected.

Connect the probe to ECM connector.

Fig 1: Locating Glove Box Lid Assembly

Courtesy of SUBARU OF AMERICA, INC.

Intake camshaft position sensor

Fig 2: Connecting Probe To ECM Connector (Intake Camshaft Position Sensor)
Courtesy of SUBARU OF AMERICA, INC.
Exhaust camshaft position sensor

Fig 3: Connecting Probe To ECM Connector (Exhaust Camshaft Position Sensor)
Courtesy of SUBARU OF AMERICA, INC.

Start the engine and let it idle.
Check that the pattern is the same as the waveform and voltage shown below.

Fig 4: Camshaft Position Sensor Signal Waveform
Courtesy of SUBARU OF AMERICA, INC.
After inspection, install the related parts in the reverse order of removal.