DTC P2122 Throttle/Pedal Position Sensor/Switch "D" Circuit Low Input: Wiring Diagram

WARNING: This page is about a different variant/trim than selected.

Fig 1: Throttle/Pedal Position Sensor/Switch "D" Circuit Low Input Wiring Diagram

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND ACCELERATOR PEDAL POSITION SENSOR CONNECTOR. Turn the ignition switch to OFF. Disconnect the connectors from ECM and accelerator pedal position sensor. Measure the resistance between ECM and chassis ground. Connector & terminal (B135) No. 21 - Chassis ground: (B135) No. 23 - Chassis ground: (B135) No. 23 - (B136) No. 4:	Is the resistance 1 MΩ or more?	Go to step 2.	Repair the short circuit to ground in harness between ECM and accelerator pedal position sensor connector.
2 CHECK SHORT CIRCUIT INSIDE THE ECM. Connect the connector to ECM. Measure the resistance between accelerator pedal position sensor connector and chassis ground. Connector & terminal (B315) No. 6 - Chassis ground:	Is the resistance 1 MΩ or more?	Replace the accelerator pedal. Refer to ACCELERATOR PEDAL Accelerator Pedal.	Repair the short circuit to ground in harness between ECM and accelerator pedal position sensor connector. Replace the ECM if defective. Refer to ENGINE CONTROL MODULE (ECM) Engine Control Module (ECM).