DTC P0024 Exhaust AVCS System 2 (Range/Performance): Trouble Symptom
WARNING: This page is about a different variant/trim than selected.
- Engine stalls.
- Improper idling
CAUTION:
After repair or replacement of faulty parts, perform Clear Memory Mode Refer to
, OPERATION , Clear Memory Mode and Inspection Mode Refer to
, PROCEDURE , Inspection Mode.
| Step | Check | Yes | No |
|---|---|---|---|
1 CHECK CURRENT DATA.
NOTE:
|
Is the exhaust AVCS system operating angle approximately 0°? | Go to step 2 . | Check the following item and repair or replace if necessary.
|
2 CHECK CURRENT DATA.
NOTE:
|
When the oil flow control solenoid valve duty output exceeds 10%, is the exhaust AVCS system operating angle approx. 0°? | Check the following item and repair or replace if necessary.
|
Perform the following procedures, and clean the oil routing. Replace the engine oil and idle the engine for 5 minutes, and then replace the oil filter and engine oil. Refer to ENGINE OIL REPLACEMENT, Engine Oil. Refer to ENGINE OIL FILTER Engine Oil Filter. |