LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical (H6DO)) >> V-belt >> Removal

Section 15 (Engine Mechanical (H6DO)): V-belt: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow the steps below when removing the collector cover.
    1. Pull up the two points at the rear (A).
    2. Pull up the two points at the front (B) while moving them forward.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the air intake duct. Refer to AIR INTAKE DUCT .
  3. Install the tool to the pulley bolt of the belt tension adjuster assembly.
  4. Rotate the tool clockwise and loosen the V-belt to remove.
    Fig 2: Removing V-Belt Using Tool
    G05667480Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals