Preparation for Overhaul: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the engine from vehicle. Refer to , REMOVAL , Engine Assembly.
Set the engine on ST.
ST 18232AA000 ENGINE STAND

Fig 1: Positioning Engine On Engine Stand
Courtesy of SUBARU OF AMERICA, INC.
Before servicing overhaul, remove the sensor, pipe and hose that installed to engine.
1. Remove the intake manifold. Refer to INTAKE MANIFOLD .
2. Remove the generator. Refer to GENERATOR .
3. Remove the A/C compressor. Refer to COMPRESSOR .
4. Disconnect the water pipe and hose.
5. Disconnect the engine harness.
6. Remove the spark plug. Refer to SPARK PLUG .
7. Remove the camshaft position sensor. Refer to CAMSHAFT POSITION SENSOR .
8. Remove the crankshaft position sensor. Refer to CRANKSHAFT POSITION SENSOR .
9. Remove the knock sensor. Refer to KNOCK SENSOR .
10. Remove the engine coolant temperature sensor. Refer to ENGINE COOLANT TEMPERATURE SENSOR .
11. Remove the oil temperature sensor. Refer to OIL TEMPERATURE SENSOR .
12. Remove the oil flow control solenoid valve. Refer to OIL FLOW CONTROL SOLENOID VALVE .
13. Remove the oil pressure switch. Refer to OIL PRESSURE SWITCH .
14. Remove the oil filter. Refer to ENGINE OIL FILTER .
15. Remove the oil cooler. Refer to OIL COOLER .