Purge Control Solenoid Valve: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the collector cover.
NOTE: Follow these procedures for removal of the collector cover.
1. Lift up the rear side holding two positions (A).
2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
  
  Fig 1: Removing Collector Cover
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the ground cable from battery.
Remove the air intake boot assembly. Refer to AIR INTAKE BOOT .
Disconnect the connector and hoses of purge control solenoid valve, and then remove the purge control solenoid valve.

Fig 2: Locating Purge Control Solenoid Valve Connector And Hoses
Courtesy of SUBARU OF AMERICA, INC.