Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the ground cable from battery.

Fig 1: Disconnecting Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.
Drain engine coolant. < Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT. >
Remove the air intake boot. < Ref. to REMOVAL , Air Intake Boot. >
Disconnect the connector (A) from the engine coolant temperature sensor, and remove the engine coolant temperature sensor.

Fig 2: Locating Engine Coolant Temperature Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.