LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Tribeca Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center - Instrumentation/Driver Info >> Combination Meter System >> Inspection >> Symptom Chart

Symptom Chart

SYMPTOM CHART

Symptom Repair order Note
Combination meter assembly does not operate.
  1. Power supply
  2. Ground circuit
  3. Combination meter
 Ref. to CHECK POWER SUPPLY AND GROUND CIRCUIT , INSPECTION, Combination Meter System.
Speedometer does not operate.
  1. VDCCM
  2. Harness
  3. Combination meter
 Ref. to CHECK VDCCM , INSPECTION, Combination Meter System.
Tachometer does not operate.
  1. ECM
  2. Harness
  3. Combination meter
 Ref. to CHECK ENGINE CONTROL MODULE (ECM) , INSPECTION, Combination Meter System.
Fuel gauge does not operate.
  1. Communication circuit
  2. Fuel level sensor
  3. Harness
  4. Combination meter
 Ref. to CHECK FUEL LEVEL SENSOR , INSPECTION, Combination Meter System.
Engine coolant temperature gauge does not operate.
  1. Communication circuit
  2. Engine coolant temperature sensor
  3. Harness
  4. Combination meter
 Ref. to CHECK ENGINE COOLANT TEMPERATURE SENSOR , INSPECTION, Combination Meter System.
Error display is shown on the odo/trip meter. Communication circuit Ref. to COMMUNICATION ERROR DISPLAY , INSPECTION, Combination Meter System.
CAUTION: When measuring the voltage and resistance of each control module or sensor, use a tapered pin with a diameter of less than 0.64 mm (0.025 in) in order to avoid poor contact. Do not insert the pin more than 2 mm (0.08 in).
scientia non olet · About LEMON Manuals