Fuel Delivery and Evaporation Lines: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Fuel Delivery And Evaporation Lines

Courtesy of SUBARU OF AMERICA, INC.

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION: Be careful not to spill fuel.

Set the vehicle on a lift.
Release the fuel pressure. Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel.
Open the fuel filler lid and remove the fuel filler cap.
Remove the floor mat. Ref. to REMOVAL , Floor Mat.
In the engine compartment, disconnect the fuel delivery hoses and evaporation hose.
CAUTION:
- Be careful not to spill fuel.
- Catch the fuel from hoses using a container or cloth.
1. Remove the connect check cover from the fuel delivery hose.
  
  Fig 2: Locating Check Cover Of Fuel Delivery Hose
  Courtesy of SUBARU OF AMERICA, INC.
2. Install the ST to the fuel pipe.
  ST 42099AE000 QUICK CONNECTOR RELEASE
3. Disconnect the quick connector of the fuel delivery hose by pushing the ST in the direction of the arrow.
4. Remove the clip and disconnect the evaporation hose from the fuel pipe.
  
  Fig 3: Identifying Fuel Delivery Hose And Evaporation Hose
  Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel tank. Ref. to REMOVAL , Fuel Tank.
Remove the rear mud guard LH. Ref. to REMOVAL , Mud Guard.
Remove the purge hose (A), purge pipe (B), vent hose (C) and drain tube assembly (D).
NOTE: Disconnect the quick connector as shown in the figure.

Fig 4: Disconnecting Quick Connector
Courtesy of SUBARU OF AMERICA, INC.

Fig 5: Locating Purge Hose, Purge Pipe, Vent Hose And Drain Tube Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel pipe assembly from vehicle.
Disconnect the quick connector, and disconnect the fuel delivery tube and fuel sub delivery tube.
1. Push the retainer in the direction of the arrow, disconnect the quick connector from pipe.
  NOTE: Clean the pipe and quick connector, if they are covered with dust.
  
  Fig 6: Disconnecting Quick Connector From Pipe
  Courtesy of SUBARU OF AMERICA, INC.
2. To prevent from damaging or entering foreign matter, wrap the pipes and quick connectors with plastic bag etc.
  
  Fig 7: Wrapping Pipes And Quick Connectors With Plastic Bag
  Courtesy of SUBARU OF AMERICA, INC.
Remove the evaporation pipe.
1. Remove the rear mud guard RH. Ref. to REMOVAL , Mud Guard.
2. Remove the evaporation hose.
  
  Fig 8: Locating Evaporation Hose Clamp
  Courtesy of SUBARU OF AMERICA, INC.
3. Remove the trunk side trim panel assembly - side on RH. Ref. to REMOVAL , Rear Quarter Trim.
4. Remove the evaporation pipe protector.
  
  Fig 9: Locating Evaporation Pipe Protector Screws
  Courtesy of SUBARU OF AMERICA, INC.
5. Remove the evaporation pipe from the vehicle.
  
  Fig 10: Locating Evaporation Pipe
  Courtesy of SUBARU OF AMERICA, INC.