LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Outback Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Exhaust System - Exhaust (H6DO - 3.6L DOHC)) >> Rear Exhaust Pipe >> Removal

Rear Exhaust Pipe: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
  1. Lift up the vehicle.
  2. Remove the rear exhaust pipe from the front exhaust pipe assembly.
    Fig 1: Locating Front And Rear Exhaust Pipe Bolts
    G06651467Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the rear exhaust pipe from the muffler.
    CAUTION: Be careful not to drop the rear exhaust pipe.
    Fig 2: Locating Rear Exhaust Pipe Bolts
    G06651478Courtesy of SUBARU OF AMERICA, INC.
  4. Apply a coat of spray type lubricant to the mating area of cushion rubber.
  5. Remove the rear exhaust pipe from the cushion rubber.
    Fig 3: Locating Cushion Rubber Rear Exhaust Pipe
    G06651479Courtesy of SUBARU OF AMERICA, INC.